ASTM F680-80(2002)
Historical Standard: ASTM F680-80(2002) Standard Test Methods for Nails
SUPERSEDED (see Active link, below)
ASTM F680
1. Scope
1.1 These test methods cover procedures for the testing of nails. The test or tests selected, and the requirements for compliance, will be as specified in the applicable product standard. Performance tests for nail withdrawal and lateral load capability are not included as they are covered by Test Methods D 1761.
1.2 The tests described are as follows:
| Section | |
| Dimensional tests | 5 |
| Tension test | 6 |
| Conventional bend test | 7 |
| Impact bend test | 8 |
| Rockwell hardness test | 9 |
| Coating weight test | 10 |
| Coating adherence test for zinc-coated nails | 11 |
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are provided for information purposes only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A90/A90M Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A428/A428M Test Method for Weight [Mass] of Coating on Aluminum-Coated Iron or Steel Articles
D1761 Test Methods for Mechanical Fasteners in Wood
E18 Test Methods for Rockwell Hardness of Metallic Materials
F547 Terminology of Nails for Use with Wood and Wood-Base Materials
F592 Terminology of Collated and Cohered Fasteners and Their Application Tools
Keywords
ICS Number Code 21.060.50
DOI: 10.1520/F0680-80R02
ASTM International is a member of CrossRef.
