ASTM G110-92(1997)
Historical Standard: ASTM G110-92(1997) Standard Practice for Evaluating Intergranular Corrosion Resistance of Heat Treatable Aluminum Alloys by Immersion in Sodium Chloride + Hydrogen Peroxide Solution
SUPERSEDED (see Active link, below)
ASTM G110
1. Scope
1.1 This practice covers the procedures for immersion tests in sodium chloride + hydrogen peroxide solution. It is primarily for tests of wrought heat treatable aluminum alloys (2XXX and 7XXX) but may be used for other aluminum alloys, including castings. It sets forth the specimen preparation procedures and the environmental conditions of the test and the means for controlling them.
1.2 This practice is intended for evaluations during alloy development and for evaluating production where it may serve as a control test on the quality of successive lots of the same material (see MIL-H-6088 and U.S. Federal Test Method Std. 151b). Therefore strict test conditions are stipulated for maximum assurance that variations in results are attributable to lot-to-lot differences in the material being tested.
Note 1-This practice does not address sampling or interpretation or significance of results.1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Other Documents
U.S. Federal Test Me Method 822.1, Intergranular Corrosion Test for Aluminum AlloysASTM Standards
D1193 Specification for Reagent Water
E3 Guide for Preparation of Metallographic Specimens
E407 Practice for Microetching Metals and Alloys
G1 Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens
G15 Terminology Relating to Corrosion and Corrosion Testing
G67 Test Method for Determining the Susceptibility to Intergranular Corrosion of 5XXX Series Aluminum Alloys by Mass Loss After Exposure to Nitric Acid (NAMLT Test)
G69 Test Method for Measurement of Corrosion Potentials of Aluminum Alloys
Keywords
2XXX aluminum alloys; 6XXX aluminum alloys; 7XXX aluminum alloys; heat treatable aluminum alloys; intergranular corrosion; intercrystalline corrosion; Aluminum alloys--corrosion testing; Corrosion--Al/Al alloys; Heat-treated aluminum alloys; Hydrogen peroxide (H 2 O 2 ); Immersion; Intercrystalline corrosion; Intergranular attack (IGA); Sodium chloride;
ICS Code
ICS Number Code 77.120.10 (Aluminium and aluminium alloys)
DOI: 10.1520/G0110-92R97
ASTM International is a member of CrossRef.