ASTM G132-96(2001)
Historical Standard: ASTM G132-96(2001) Standard Test Method for Pin Abrasion Testing
SUPERSEDED (see Active link, below)
ASTM G132
1. Scope
1.1 This test method covers a laboratory procedure for determining the wear resistance of a material when relative motion is caused between an abrasive cloth or paper and a contacting pin of the test material. The principal factors and conditions requiring attention when using this type of apparatus to measure wear are discussed.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A128/A128M Specification for Steel Castings, Austenitic Manganese
A514/A514M Specification for High-Yield-Strength, Quenched and Tempered Alloy Steel Plate, Suitable for Welding
E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
F732 Test Method for Wear Testing of Polymeric Materials Used in Total Joint Prostheses
G40 Terminology Relating to Wear and Erosion
G99 Test Method for Wear Testing with a Pin-on-Disk Apparatus
Keywords
abrasion; abrasives; tribology; wear; wear resistance;
ICS Code
ICS Number Code 19.060 (Mechanical testing)
DOI: 10.1520/G0132-96R01
ASTM International is a member of CrossRef.
