ASTM G76-05
Historical Standard: ASTM G76-05 Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets
SUPERSEDED (see Active link, below)
ASTM G76
1. Scope
1.1 This test method covers the determination of material loss by gas-entrained solid particle impingement erosion with jetnozzle type erosion equipment. This test method may be used in the laboratory to measure the solid particle erosion of different materials and has been used as a screening test for ranking solid particle erosion rates of materials in simulated service environments (1, 2) . Actual erosion service involves particle sizes, velocities, attack angles, environments, and so forth, that will vary over a wide range (3-5) . Hence, any single laboratory test may not be sufficient to evaluate expected service performance. This test method describes one well characterized procedure for solid particle impingement erosion measurement for which interlaboratory test results are available.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process
G40 Terminology Relating to Wear and Erosion
American National Standard
ANSI B74.10 Grading of Abrasive Microgrits Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.Keywords
erosion; erosion rate; gas jet; metal erosion; solid particle ;
ICS Code
ICS Number Code 77.060 (Corrosion of metals)
DOI: 10.1520/G0076-05
ASTM International is a member of CrossRef.
