ASTM G99-95a(2000)e1
Historical Standard: ASTM G99-95a(2000)e1 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
SUPERSEDED (see Active link, below)
ASTM G99
1. Scope
1.1 This test method describes a laboratory procedure for determining the wear of materials during sliding using a pin-on-disk apparatus. Materials are tested in pairs under nominally non-abrasive conditions. The principal areas of experimental attention in using this type of apparatus to measure wear are described. The coefficient of friction may also be determined.
1.2 The values stated in SI units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E178 Practice for Dealing With Outlying Observations
G40 Terminology Relating to Wear and Erosion
G117 Guide for Calculating and Reporting Measures of Precision Using Data from Interlaboratory Wear or Erosion Tests
DIN Standard
DIN50324 Testing of Friction and WearKeywords
ceramic wear; friction; metal wear; non-abrasive; pin-on-disk; wear; Ceramic wear testing; Linear changes/linearity--metals/alloys; Nonabrasive testing; Pin-on-disk wear apparatus; Sliding; Wear testing--metallic materials;
ICS Code
ICS Number Code 17.040.20 (Properties of surfaces)
DOI: 10.1520/G0099-95AR00E01
ASTM International is a member of CrossRef.
