|
FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionThis standard describes the material and application of shop-applied and field-applied liquid-epoxy coatings and linings used in the water-supply industry for steel water pipe, special sections, welded joints, connections, and fittings installed underground or underwater, under normal construction conditions. 1.1.1 Conditions not described in this standard. The coating systems described in this standard are not intended for use on pipe that will be bent after the coating or lining system has been applied. 1.1.2 Coating and lining systems. The coating and lining systems may consist of any of the following three types: (1) a two-part chemically cured epoxy primer and one or more coats of a different two-part chemically cured epoxy topcoat; (2) two or more coats of the same two-part chemically cured epoxy, in which case the first coat shall be considered as the prime coat; or (3) a single coat of a two-part chemically cured epoxy. 1.1.3 Maximum temperature. AWWA steel pipe coating and lining standards are based on the maximum service temperature of potable water. Consult the epoxy manufacturer for conditions and limitations. 1.1.4 Other substrates. When this standard is referenced for substrates other than carbon steel, the surface preparation methods, application methods and performance data listed in this standard may not be applicable and the coating manufacturer should be consulted. This standard can be referenced in documents for liquid-epoxy coatings and linings for steel water pipe and fittings. The stipulations of this standard apply when this document has been referenced and then only to liquid-epoxy coatings and linings for steel water pipe and fittings.Subscription InformationMADCAD.com AWWA Standards & Manuals subscriptions are annual and access is concurrency based (number of people that can access the subscription at any given time).
Some features of MADCAD.com AWWA Standards & Manuals Subscriptions are:
- Floating concurrency model: Set your concurrency level and share your AWWA Standards & Manuals Subscriptions among your offices enterprise-wide.
- Immediate Access: As soon as the transaction is completed, your AWWA Standards & Manuals Subscription will be ready for access.
For any further information on MADCAD.com AWWA Standards & Manuals Subscriptions, please contact us at info@madcad.com or +1 800.798.9296.
About AWWAEstablished in 1881, the American Water Works Association is the oldest and largest nonprofit, scientific and educational organization dedicated to safe and sustainable water in the world. With more than 50,000 members worldwide and 43 Sections in North America, AWWA advances public health, safety and welfare by uniting the efforts of the entire water community. AWWA Offers education to water professionals Advocates for safe and sustainable water Collects and share knowledge Creates volunteering opportunities |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|