|
FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS EN 16603-10-02:2018 - TC 2020This Standard establishes the requirements for the verification of a space system product. It defines the fundamental concepts of the verification process, the criteria for defining the verification strategy and specifies the requirements for the implementation of the verification programme. It includes also the list of the expected documentation (i.e. Document requirements definitions, DRDs). This Standard is intended to apply to different products at different levels from a single equipment to the overall system. Discipline related verification aspects are complemented in Standards specific to those disciplines. For verification process for SW the following standards are considered fully sufficient for development of these items: - ECSS-E-ST-40 Space engineering - Software - ECSS-Q-ST-80 Space product assurance - Software product assurance Detailed requirements for Testing are covered in the ECSS E-ST-10-03. This standard does not specifically address Validation of space products as a separate process, since product Verification is performed against requirements that also address the suitability of the product to fulfil the needs of its intended use. As such, Validation is achieved through the Verification process provided adequate requirements are placed on the product. It is recognised that testing and analysis also occur during the product development process, but they are not addressed by this standard as they are not formal requirement verification activities in the sense of the customer-supplier relationship. The guidelines on verification are provided in the associated handbook ECSS-E-HB-10-02A. The requirements on the systems engineering process are gathered in ECSS-E-ST-10 'System Engineering'; specific aspects of the SE process are further elaborated in dedicated standards, in particular: ECSS-E-ST-10-06 'Technical Specification', ECSS-E-ST-10-02 'Verification' (the present standard), and ECSS-E-ST-10-03 'Testing'. These standards are based on the same principles, process and documentation model. The applicability of each these standards can therefore not be considered in isolation from the others This standard may be tailored for the specific characteristic and constraints of a space project in conformance with ECSS-S-ST-00.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|