FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS EN 60704-2-13:2017 2017This clause of Part 1 is applicable except as follows: 1.1 Scope1.1.1 GeneralAddition: These particular requirements apply to electrical range hoods and other cooking fume extractors for household and similar use intended for filtering the air of a room or for exhausting the air out of a room, including their accessories and their component parts. It also applies to cooking fume extractors with an external fan which may be mounted inside or outside of the room where the range hood is located or a down-draft system that is arranged beside, behind or under the cooking surface. 1.1.2 Types of noiseReplacement: The methods specified in ISO 3743‑1 , ISO 3743‑2 and ISO 3744 can be used for measuring noise emitted by cooking fume extractors. 1.1.3 Size of sourceReplacement: The method specified in ISO 3744 is applicable to noise sources of any size. When applying ISO 3743‑1 and ISO 3743‑2 , care should be taken that the maximum size of the cooking fume extractor under test fulfils the requirements specified in 1.2 of ISO 3743‑1 and 1.3 of ISO 3743‑2 . 1.2 ObjectAddition: This standard describes the determination of the noise emission of household cooking fume extractors under normal operating conditions and at the highest fan speed setting for normal use. NOTE 101 If a boost position is incorporated, this is not taken into account (see 6.5 of IEC 61591:1997 ). NOTE 102 A boost position is a setting of a control for occasional use, which results in a higher temporary fan speed (see 6.5 of IEC 61591:1997 ). Requirements for the declaration of noise emission values are not within the scope of this standard. NOTE 103 For determining and verifying noise emission values declared in product specifications, see IEC 60704‑3 . 1.3 Measurement uncertaintyReplacement: The estimated values of standard deviations of sound power levels, determined according to this standard, are as follows (see Table 101): Table 101 Standard deviations of sound power levels
Addition: 1.101 Standard deviation for declaration and verificationFor the purpose of determining and verifying declared noise emission values according to IEC 60704‑3 , the following values apply (see Table 102): Table 102 Standard deviations for declaration and verification
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|