Description of BS EN IEC 60793-1-54:2018 - TC 2020

IEC 60793-1-54:2018 is also available as /2 which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.

IEC 60793-1-54:2018 outlines a method for measuring the steady state response of optical fibres and optical cables exposed to gamma radiation. It can be employed to determine the level of radiation-induced attenuation produced in Class B single-mode or Class A, category A1 and A2 multimode optical fibres, in either cabled or uncabled form, due to exposure to gamma radiation. The attenuation of cabled and uncabled optical fibres generally increases when exposed to gamma radiation. This is primarily due to the trapping of radiolytic electrons and holes at defect sites in the glass (i.e. the formation of 'colour centres'). This test procedure focuses on two regimes of interest: the low dose rate regime suitable for estimating the effect of environmental background radiation, and the high dose rate regime suitable for estimating the effect of adverse nuclear environments. The testing of the effects of environmental background radiation is achieved with an attenuation measurement approach similar to IEC 60793-1-40 method A, cut-back. The effects of adverse nuclear environments are tested by monitoring the power before, during and after exposure of the test sample to gamma radiation. The depopulation of colour centres by light (photo bleaching) or by heat causes recovery (lessening of radiation induced attenuation). Recovery can occur over a wide range of time which depends on the irradiation time and annealing temperature. This complicates the characterization of radiation induced attenuation since the attenuation depends on many variables including the temperature of the test environment, the configuration of the sample, the total dose and the dose rate applied to the sample and the light level used to measure it. This test is not a material test for the non-optical material components of a fibre optic cable. If degradation of cable materials exposed to irradiation is studied, other test methods will be used. This test method is written to contain a clear, concise listing of instructions. The background knowledge that is necessary to perform correct, relevant and expressive irradiation tests as well as to limit measurement uncertainty is presented separately in IEC TR 62283. This third edition cancels and replaces the second edition published in 2012. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:
- test conditions related to photobleaching have been changed;
- the test length has been modified to yield a total induced attenuation in the test sample at the end of the irradiation between 3 dB and 10 dB.

Standard Number	BS EN IEC 60793-1-54:2018 - TC
Title	Tracked Changes. Optical fibres - Measurement methods and test procedures. Gamma irradiation
Status	Definitive
Publication Date	2020-02-27
Descriptors	Electronic equipment and components, Radiolysis, Wave properties and phenomena, Fibre optic cables, Optical measurement, Test methods, Defects, Electromagnetic radiation, Attenuation, Fibre optics, Electrons, Laboratory testing, Environmental testing, Safety devices, Optical fibres, Temperature measurement, Gamma-radiation, Test equipment, Optical communication systems, Test specimens
ICS	33.180.10 Fibres and cables
Committee	GEL/86/1
ISBN	978 0 539 11886 5
Publisher	BSI
Pages	0

About BSI

BSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses.