FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS ISO 5415:2007 2008This International Standard specifies the dimensions of reduction sleeves with 7/24 external taper No. 30-40-45-50 and 60 and Morse internal taper No. 1 to 6 (Morse taper No. 4, 5 and 6 being either with positive drive, see Figure 2, or without positive drive, see Figure 1). These sleeves permit driving of tools with Morse taper shanks with tapped holes with the aid of an internal screw. The form of this screw and its fixation in the sleeve are left to the manufacturer's discretion. 7/24 tapers are in accordance with ISO 297. Morse tapers are in accordance with ISO 296 and ISO 5413.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|