ASTM D4551-96(2008)e1
Historical Standard: ASTM D4551-96(2008)e1 Standard Specification for Poly(Vinyl Chloride) (PVC) Plastic Flexible Concealed Water-Containment Membrane
SUPERSEDED (see Active link, below)
ASTM D4551
1. Scope
1.1 This specification covers poly(vinyl chloride) (PVC) flexible sheeting which is used without mastic, bedding, or coating for construction of concealed water-containment-membranes in applications where there is potential for costly secondary damage from water leakage and very long-term reliable performance is essential. Examples are fountains, pools, planters, shower and safe pans, tile tubs, or similar wet installations where the membrane is inaccessible once the construction is complete. Included are requirements for materials and sheeting, test methods, workmanship criteria, and methods of marking.
1.2 Recycled materials may be used in this product in accordance with the requirements in Section 5.
1.3 The tests are intended to ensure quality and performance and are not intended for design purposes. Tests have been selected to be conducted primarily with liquids that simulate the environment to which the membrane will be subjected during actual use.
1.4 This specification does not cover water-containment membranes exposed to ultraviolet light.
1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.6 There is no known ISO equivalent to this standard.
1.7 The following precautionary caveat pertains only to the test method portion, Section 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D374 Test Methods for Thickness of Solid Electrical Insulation
D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension
D543 Practices for Evaluating the Resistance of Plastics to Chemical Reagents
D618 Practice for Conditioning Plastics for Testing
D883 Terminology Relating to Plastics
D1004 Test Method for Tear Resistance (Graves Tear) of Plastic Film and Sheeting
D1203 Test Methods for Volatile Loss From Plastics Using Activated Carbon Methods
D1204 Test Method for Linear Dimensional Changes of Nonrigid Thermoplastic Sheeting or Film at Elevated Temperature
D1243 Test Method for Dilute Solution Viscosity of Vinyl Chloride Polymers
D3892 Practice for Packaging/Packing of Plastics
D7209 Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products
E96/E96M Test Methods for Water Vapor Transmission of Materials
Military Standard
MIL-STD-105 Sampling Procedures and Tables for Inspection by Attributes Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.ANSI Standard
Z 26.1 Safety Code for Safety Glazing Materials for Glazing Motor Vehicles Operating on Land Highways Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
flexible sheeting; fountains; planters; pools; poly(vinyl chloride); PVC; recycle usage; shower and safe pans; tile tubs; water containment membrane; water leakage resistance; water permeation ;
ICS Code
ICS Number Code 83.140.10 (Films and sheets)
DOI: 10.1520/D4551-96R08E01
ASTM International is a member of CrossRef.