ASTM D5947-96
Historical Standard: ASTM D5947-96 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
SUPERSEDED (see Active link, below)
ASTM D5947
1. Scope
1.1 These test methods cover determination of the physical dimensions of solid plastic specimens where the dimensions are used directly in determining the results of tests for various properties. Use these test methods except as otherwise required in material specifications.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no similar or equivalent ISO standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D638 Test Method for Tensile Properties of Plastics
D790 Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials
D883 Terminology Relating to Plastics
D2240 Test Method for Rubber Property--Durometer Hardness
ISO Standards
ISO 16012 Plastics--Determination of Linear Dimensions of Test SpecimensKeywords
caliper; dimensions; elastomers; micrometer; plastics; Caliper; Dimensions--plastic materials/applications; Elastomeric materials/applications; Micrometer measurement; Physical properties/dimensions/characteristics; Solid plastics
ICS Code
ICS Number Code 83.080.01 (Plastics in general)
DOI: 10.1520/D5947-96
ASTM International is a member of CrossRef.
