ASTM D6040-96
Historical Standard: ASTM D6040-96 Standard Guide to Standard Test Methods for Unsintered Polytetrafluoroethylene (PTFE) Extruded Film or Tape
SUPERSEDED (see Active link, below)
ASTM D6040
1. Scope
1.1 This guide identifies test methods to use in evaluating unsintered extruded films or tapes manufactured from polytetrafluoroethylene.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no ISO standard that covers all of the information included in this guide. A few of these test methods are mentioned in ISO 12086-2:1995.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
D150 Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation
D257 Test Methods for DC Resistance or Conductance of Insulating Materials
D374 Test Methods for Thickness of Solid Electrical Insulation
D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
D882 Test Method for Tensile Properties of Thin Plastic Sheeting
D883 Terminology Relating to Plastics
D1711 Terminology Relating to Electrical Insulation
D3776 Test Methods for Mass Per Unit Area (Weight) of Fabric
F335 Terminology Relating to Electrostatic Imaging
F412 Terminology Relating to Plastic Piping Systems
ISO Standard
ISO12086-2:2006 Plastics--Fluoropolymer Dispersions and Moulding and Extrusion Materials--Part 2: Preparation of Test Specimens and Determination of Properties Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
dielectric breakdown voltage; dielectric constant; elongation; lubricated PTFE; paste extruded PTFE; PTFE; specific gravity; tensile properties; unsintered PTFE; virgin; volatiles; volume resistivity ;
ICS Code
ICS Number Code 83.080.20 (Thermoplastic materials)
DOI: 10.1520/D6040-96
ASTM International is a member of CrossRef.
