ASTM D7192-05
Historical Standard: ASTM D7192-05 Standard Test Method for High Speed Puncture Properties of Plastic Films Using Load and Displacement Sensors
SUPERSEDED (see Active link, below)
ASTM D7192
1. Scope
1.1 This test method covers the determination of puncture properties of plastic films, over a range of test velocities.
1.2 Test data obtained by this test method is relevant and appropriate for use in engineering design.
1.3 The values stated in SI units are to be regarded as standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1This test method does not closely conform to ISO 7765-2. The only similarity between the two tests is that they are both instrumented impact tests. The differences in striker, fixture, specimen geometries and in test velocity can produce significantly different test results.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D883 Terminology Relating to Plastics
D1004 Test Method for Tear Resistance (Graves Tear) of Plastic Film and Sheeting
D1600 Terminology for Abbreviated Terms Relating to Plastics
D3763 Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors
D4000 Classification System for Specifying Plastic Materials
D6988 Guide for Determination of Thickness of Plastic Film Test Specimens
Keywords
falling weight; impact testing; plastic thin film; puncture properties; Falling weight test; Impact testing; Plastic film; Puncture testing;
ICS Code
ICS Number Code 83.140.10 (Films and sheets)
DOI: 10.1520/D7192-05
ASTM International is a member of CrossRef.
